Til kassen
Totalt: 0,-
Handlekurv / 0 produkter

Handlekurven er tom

Usikker på hvor du skal starte?
Se våre nyheter
Til kassen
Total: 0,-

NYHET! Opphengskule (bærekule) - vedlikeholdsfri

På lager: 3
Art.nr: C-GSJ166
1.195,-
Vennligst velg

NYHET! Opphengskule (bærekule) - vedlikeholdsfri

Produktet er midlertidig utsolgt. Dersom du ønsker å motta en epost når vi får det inn på lager, kan du legge igjen epostadressen din i skjemaet under.

Nyutviklet opphengskule som ikke trenger noe shimsing eller smøring. Utviklet og testet over en treårsperiode i Japan. 

 

Produsentens info:

Developed and tested over a period of three years, the original concept was to manufacture a high quality product, similar to those used on modern vehicles. Unlike the current design, the maintenance free ball joints do not require periodic adjustments of the shim, and are pre-loaded for easy installation. Mounted in the same way as the original, these are a direct replacement, and can be fitted to the top and bottom without upsetting the suspensions geometry.

With no shimming required, fitting the maintenance free ball joints can be done in a relatively short period of time. For those without a deep socket, simply remove the dust boot prior to fitting, and tighten to torque. While the rubber dust boot is highly durable, care should be taken when securing the blue retainer clip. To prevent water from entering the joint, grease is recommended to extend the lifespan. Other than for exceptional circumstances, does not require additional grease-up once fitted.

Estimated lifespan of up to 10 years or 50,000kms. Sold individually.

Torque ball joint socket to hub 70-80lbft, ball joint to suspension arms 35-40lbft.

NOT SUITABLE FOR RACE CARS SUCH AS, MINI7, MIGLIA, MINI7 S CLASS AND LIBRA.

Relaterte produkter

×
Produktet du valgte er lagt i handlekurven